GS716Tv3/GS724Tv4/GS748Tv5 Firmware Version 6.3.1.9

Fixed issues

• Fixed the SNMP display and conversion issues related to AgentTransferDownloadGroup and LLDRemManAddrTable
• Fixed the problem of not getting response using SNMPGet with UDP broadcast (IP: 255.255.255.255) to port 161
• Fixed the issue where system locks up when performing a SNMP GET on MIB object - dot1qVlanForbiddenEgressPorts
• Fixed the problem of unexpected result is seen when setting and getting the value of MIB object - StaticUntaggedPorts on VLAN 1
• Fixed the issue where GS748Tv5 keeps getting the following error message “Fan state change alarm: Fan ID: 1 Event: 3” in memory log
• Fixed the problem of not able to add SNTP sever with specific IPv4 address such as 172.22.6.224~254
• Fixed the problem where SNMP(v1) TRAP always shows its agent IP as 192.168.0.239
• Fixed the issue where 802.1x Authentication would fail with “Authentication Fails, Reason Code 23” in the event viewer log when PEAP is used

Known issues

1. Warning messages pop up when the HTTPS admin status is enabled.
   [Workaround]: Refresh the GUI screen.
2. The cable test results sometimes show a much longer value.
   [Workaround]: Redo the cable test on the same port.

Notes and limitations

• Configuration migration from the old GS716Tv2, GS724Tv3, and GS748Tv4 switches to the new GS716Tv3, GS724Tv4, and GS748Tv5 switches is not supported.
• The boot time for the new GS716Tv3, GS724Tv4, and GS748Tv5 switches is about 40 seconds longer than for the old GS716Tv2, GS724Tv3, and GS748Tv4 switches.
• During the boot time (about 2 minutes), all LEDs light on the new GS716Tv3 and GS724Tv4 switches. This feature is working as designed.