更改： - 修正了超额认购的接收缓冲区时，没有启用流量控制造成的RX管道挂起。 - 修正了一个导致固件运行ibdiagnet时挂起。所接收的DiagData MAD包括以下值：Clear_all = 1，页次= 0，Port_select = 0。为了防止固件从挂，一个端口检查加入到设置（）为好。 - 修正了一个导致端口2的GPIO存在的问题被映射到的ConnectX-4 EN 50GbE单端口适配卡OPN...
This package contains the files needed for installing the Mellanox MCX455A-FCAT VPI Card Firmware. If it has been installed, updating (overwrite-installing) may fix problems, add new functions, or expand existing ones. Even though other OSes might be...
有什么新的6.32.3： - 开关 - 设置回重新启动后的默认值固定CRS设置; - 网络安装 - 包括缺少RB1200驱动程序; - 防火墙 - 固定连接速率匹配; - PPP，PPTP，L2TP，PPPoE协议：固定路由器死亡压缩的情况环节上启用锁定; - 快干 - 建立适当的防火墙规则时，PPPoE可用于获取IP地址; - SSTP - 当对方开始在中间分段PPP报文的固定内核崩溃; - ippool6 - 优化相同前缀的采集; - WINBOX - SHIFT +...
Changes: - Lowered the externally managed switches default fan speed from 80% to 60% - Added congestion control attribute “PORT_VL_XMIT_TIME_CONG” according to 3.23 CounterGroupInfo in Vendor Specific MADs version 1.1 - Added support for...
Fixes: - The first Read response was not treated as implicit ACK - Reduced a long 40GbE link up time with Cisco Nexus 3064 and Arista-7050S...
Fixes: - The first Read response was not treated as implicit ACK - Reduced a long 40GbE link up time with Cisco Nexus 3064 and Arista-7050S...
Fixes: - The first Read response was not treated as implicit ACK - Reduced a long 40GbE link up time with Cisco Nexus 3064 and Arista-7050S...
Changes: - Support multiple RoCE modes (RoCE v1+v2) on the same port: RoCE mode is per connection now. - Added a new QP command “INIT2RTS_QP” to enhance QP connection readiness time. - Disabled FCS checks to support switches that replace FCS...
更改： - 降低了外部管理的交换机默认风扇转速从80％至60％ - 增加了拥塞控制的属性和ldquo; PORT_VL_XMIT_TIME_CONG＆rdquo;的根据3.23 CounterGroupInfo在厂商特定MADS 1.1版 - 增加了对每L4传输层自适应路由支持修正： - 意外的LED行为一旦LED供应商特定MAD配置任何端口LED指示灯闪烁模式。 - 修正了部分下降随机。 -...
更改： - 降低了外部管理的交换机默认风扇转速从80％至60％ - 增加了拥塞控制的属性和ldquo; PORT_VL_XMIT_TIME_CONG＆rdquo;的根据3.23 CounterGroupInfo在厂商特定MADS 1.1版 - 增加了对每L4传输层自适应路由支持修正： - 意外的LED行为一旦LED供应商特定MAD配置任何端口LED指示灯闪烁模式。 - 修正了部分下降随机。 -...
